Wisesorb Activated Alumina Desiccant 0.91 kg (2 LBS) | Moisture Absorber for Filament Drying

• Activated Alumina — utilize premium quality raw material with an extremely porous structure and high surface area-to-mass ratio, high strength against crushing and very stable physical and chemical characteristics, even in high temperature and corrosive environments. At 77℉/25℃, RH90%, it can absorb more than 30% of its weight in water vapor. Each bead is 3 – 5mm in size.
• Activated Alumina — which has excellent porosity creating tortuous paths and extended surface area can be used in both heated and pressure swing dryers. It has stable physical and chemical characteristics, even in high temperature and corrosive environments.
• Activated Alumina — has a wide variety of applications, including compressed air and gas drying. In compressed air and gas drying applications, activated alumina can achieve dew points -100°F/-73℃, depending on the dryer. It is suitable for deep drying under pressure greater than 5kg/cm2.
• How to Use — Place activated alumina into watertight dryer or container and then place dryer or container into the compress air or gas system. Desiccant Activated Alumina ( Aluminum Oxide) Desiccant is perfect for drying air and most other gases with relatively high humidity.
• How to Regenerate — 1. Use the dry gas under lower pressure or higher temperature to pass the activated alumina. 2. Use wet gas which is heated or decompressed to pass the activated alumina. The reusable activated alumina beads desiccant dehumidifier can be reactivated by placing into the oven for 8 hours at 200°C-250°C (do not over 250°C).

• Place the Wisesorb Activated Alumina beads into a suitable watertight container or a dedicated filament dryer. Ensure the container is sealed to prevent any external moisture from entering. — Prepare for Drying
• Position the container with the desiccant into the system requiring drying. This could be alongside a spool of 3D printer filament, within a compressed air dryer, or in any sealed environment needing moisture control. — Place in System
• Periodically check the desiccant's effectiveness. When moisture absorption capacity decreases, reactivate by placing the beads in an oven at 200°C-250°C for approximately 8 hours. Do not exceed 250°C. — Monitor and Reactivate

Typical situations where Wisesorb Activated Alumina Desiccant 0.91 kg (2 LBS) | Moisture Absorber for Filament Drying helps — illustrative scenarios, not customer reviews.