Wisesorb Activated Alumina Desiccant 12 LBS (5.44 kg) | Reusable Moisture Absorber for Filament Drying

• Activated Alumina — utilize premium quality raw material with an extremely porous structure and high surface area-to-mass ratio, high strength against crushing and very stable physical and chemical characteristics, even in high temperature and corrosive environments. At 77℉/25℃, RH90%, it can absorb more than 30% of its weight in water vapor. Each bead is 3 – 5mm in size.
• Activated Alumina — which has excellent porosity creating tortuous paths and extended surface area can be used in both heated and pressure swing dryers. It has stable physical and chemical characteristics, even in high temperature and corrosive environments.
• Activated Alumina Has a Wide Variety of Applications — Including compressed air and gas drying. In compressed air and gas drying applications, activated alumina can achieve dew points -100°F/-73℃, depending on the dryer. It is suitable for deep drying under pressure greater than 5kg/cm2.
• How to Use — Place activated alumina into watertight dryer or container and then place dryer or container into the compress air or gas system. Desiccant Activated Alumina ( Aluminum Oxide) Desiccant is perfect for drying air and most other gases with relatively high humidity.
• How to Regenerate — 1. Use the dry gas under lower pressure or higher temperature to pass the activated alumina. 2. Use wet gas which is heated or decompressed to pass the activated alumina. The reusable activated alumina beads desiccant dehumidifier can be reactivated by placing into the oven for 8 hours at 200°C-250°C (do not over 250°C).

• Prepare the Desiccant — Ensure the Wisesorb Activated Alumina beads are dry and ready for use. If previously used, regenerate them by heating in an oven at 200°C-250°C for 8 hours.
• Place in Drying Container — Put the activated alumina beads into a watertight dryer or container. Ensure the container is appropriately sized for the amount of desiccant and the items being protected.
• Integrate into System — Place the filled container into your compressed air system, gas dryer, or filament storage enclosure. For filament drying, ensure the container is sealed to maintain low humidity.
• Monitor and Regenerate — Periodically check the moisture level or the desiccant's saturation. When capacity is reduced, regenerate the beads as per instructions to maintain optimal performance.

Typical situations where Wisesorb Activated Alumina Desiccant 12 LBS (5.44 kg) | Reusable Moisture Absorber for Filament Drying helps — illustrative scenarios, not customer reviews.