Turcee T-Car Sunroof Cover Seal Rubber Trim 7M (23Ft) | Seals Gaps Against Dust, Water & Wind Noise

• Upgrade T-Car Weather Strip: Don't put up with the large gap between the front windshield and sunroof causing leakage into dust and the terrible wind noise on the highway! The upgraded T-seal strip can perfectly fill the gap between the front windshield,rear windshield, sunroof and frame
• Easy to Install: Thoroughly clean the installation surface; keep the installation environment temperature between 50°F - 85°F. In case of low temperatures, preheat the sealing strip indoors in advance; to ensure waterproofness, cut the end of the sealing strip at a 45° angle for a tight joint; use the attached adhesive-promoting wet wipes (check the humidity before use) to wipe the installation surface, and press firmly for 30 seconds after installation
• Wide Range of Protection: 30mm*7M T-edge seal strip can be cut upon need for any car small sunroof(3M),panoramic sunroof(7M),both sides of windshield(2M),both sides of rear windshield(2M),etc. Note: The sunroof cannot be opened again after the rubber sealing strip is installed
• Installation Note: The effective temperature range for the product to maintain its adhesiveness is 50°F - 85°F. Avoid using it in extremely high or low temperatures (below 45°F). If it is necessary to use it in extreme temperatures, it is recommended to use it with 3M sealing strip adhesive
• Notes: The thickness of this product is only 3mm/0.12inch, which is relatively thin and not easy to bulge. The width is 30mm. It is recommended that you measure the gap you need to fill before purchasing to avoid incompatibility issues

• Prepare the Surface — Thoroughly clean the installation area on your car's sunroof, windshield, or tailgate. Ensure the surface is dry and free from dust, oil, or wax. For best adhesion, maintain an ambient temperature between 50°F - 85°F (10°C - 29°C).
• Cut and Apply the Seal — Measure and cut the 7-meter (23-foot) strip to your required length. If needed, preheat the strip indoors in cold temperatures. Apply the strong adhesive backing firmly, pressing down for at least 30 seconds to ensure a secure bond.
• Ensure a Tight Joint — For optimal waterproofness, consider cutting the end of the sealing strip at a 45-degree angle where joints meet. After installation, press firmly along the entire length to ensure a complete and tight seal against the car body.

Typical situations where Turcee T-Car Sunroof Cover Seal Rubber Trim 7M (23Ft) | Seals Gaps Against Dust helps — illustrative scenarios, not customer reviews.