HPFIX Thermal Adhesive Tape 20mm x 25m (0.79in x 82ft) | High Thermal Conductivity Fiberglass Tape

• HPFIX thermal adhesive Tape is a simple and practical heat conductive tape, very easy to use, even for beginners.
• Thermally conductive tape has very strong adhesion and has good thermal conductivity. It is often used on heat sinks- efficiently transfer heat dissipation for electronics. If combined with thermal paste, the effect will be better.
• HPFIX thermal tape has thermal conductivity 1.5 W/m-k to meet most of electronics heat dissipation demands.
• Thermal tape is widely used for high power LED,High power power supply, Computer CUP, GPU, automotive electronic heating module, motor controller, communication equipment, power semiconductor, MOS tube,GBT chip,Video Card RAM, DDR Memory Modules, SSD drives, new energy heating power.
• Themral tape heat conductivity is high and stable, its life is longer than the general heat-dissipating double-sided sticker, and it can work for at least 5 years at normal temperature (80-120°C ).

• Prepare Surfaces — Ensure the surfaces where the tape will be applied are clean, dry, and free from dust, oil, or other contaminants. For optimal adhesion, wipe surfaces with isopropyl alcohol and allow them to dry completely.
• Apply Tape — Carefully peel off the protective liner from one side of the tape. Align and press the tape firmly onto the first surface. Then, peel off the second liner and press the tape onto the second surface, ensuring even pressure.
• Ensure Maximum Adhesion — Apply firm, even pressure across the entire taped area. For best results, allow the adhesive to cure for at least 72 hours at room temperature. Gentle heating (60-70°C) can accelerate this process, especially in cooler environments.

Typical situations where HPFIX Thermal Adhesive Tape 20mm x 25m (0.79in x 82ft) | High Thermal Conductivity Fiberglass Tape helps — illustrative scenarios, not customer reviews.