YAMAKATO 1/4 Inch ID 6FT NBR Fuel Line Hose SAE 30R7 with 10 Clamps | Reinforced Braided Hose for Small Engines

• A nylon braid fuel line for Kawasaki Kohler Briggs & Stratton Yamaha John Deere Tecumseh Small Gas Diesel Engines Generators. For vapor emission and vacuum smog control. This item meets the SAE J30R7 standard and is capable of operating under a pressure of up to 60 psi.
• Package includes one 6 feet fuel line and 10pcs Hose Clamps. quarter inch or 6.4mm inner diameter and 1/2 inch outer diameter (13mm). The Hose Clamp is 12~16mm inner diameter, made of stainless steel.
• The fuel line are oil resistant, hot and cold resistant from -22F to 248F and ethanol tolerance; working pressure: 60psi; burst pressure 249psi.
• Designed for conveying gasoline, oil, E-85, diesel, and bio-diesel, fuels in marine boat, oil cooling, steam vent emission, PCV system applications, automotives, lawn mowers, tillers, tractors, snow blowers, motorcycles, mini bikes, generators, trash water pumps, pit bikes, ATV, go karts, 4 wheelers, and just about all small engines with 6mm to 7mm fuel lines.
• The fuel line can be cut to be replacements for Tecumseh 430173, 30962, 30705, and for Briggs and Stratton 791745, 056-150, 395051R, 5414K, 791744, 691050, 394302, 798512, 809499, and 791766 fuel lines.

• Measure and Cut Hose — Determine the required length for your application. Use a sharp utility knife or hose cutter to cleanly cut the 6-foot YAMAKATO fuel line to your specific measurement, ensuring a straight edge for a proper seal.
• Attach Hose Clamps — Slide one of the included 12-16mm stainless steel hose clamps onto each end of the cut fuel line. Position the clamp approximately 1/4 inch from the hose end, ensuring it will sit over the fuel fitting on your engine or tank.
• Connect Fuel Line — Firmly push the fuel line onto the appropriate fuel fitting on your engine's carburetor or fuel tank. Ensure the hose is fully seated on the fitting, then slide the hose clamp over the connection point and tighten securely with a screwdriver.
• Test for Leaks — After installation, turn on the fuel supply and check all connection points for any signs of fuel leakage. Start the engine and re-inspect for leaks under operating pressure. Tighten clamps if necessary.

Typical situations where YAMAKATO 1/4 Inch ID 6FT NBR Fuel Line Hose SAE 30R7 with 10 Clamps | Reinforced Braided Hose for Small Engines helps — illustrative scenarios, not customer reviews.