uxcell Red Silicone O-Ring 16mm OD x 14mm ID x 1mm Width | Pack of 30 VMQ Seal Rings

• Size — 16mm Outside Diameter, 14mm Inner Diameter, 1mm Cross-Section Diameter
• Hardness — 50 Durometer (Shore Hardness) for resistance to penetration
• VMQ — Standard silicone with a wide temperature range from -22℉ (-30℃) to 392℉ (200℃)
• Application — Can be used for travel mug cup lids, espresso coffee maker and weldless fitting for brewing
• Application — Widely used for Hydraulics and Pneumatics sealing, pressure valve, gas compressor, reaction valve, heat exchanger, boiler, filter, mechanical

• Select the Correct Size — Choose an O-ring from the 30-pack that precisely matches your groove dimensions: 16mm outer diameter, 14mm inner diameter, and 1mm cross-section. Ensure the O-ring fits snugly without stretching excessively.
• Prepare the Mating Surfaces — Clean both the groove and the mating surface thoroughly to remove any dirt, debris, or old sealant. This ensures a smooth, uninterrupted seal and prevents damage to the new O-ring.
• Install the O-Ring — Carefully place the O-ring into the designated groove. Avoid using sharp tools that could nick or cut the silicone. Once seated, assemble the components to create the pressure and fluid seal.
• Verify the Seal — After assembly, test the seal under the intended operating conditions (temperature, pressure, fluid type) to confirm it is leak-free and performing as expected.

Typical situations where uxcell Red Silicone O-Ring 16mm OD x 14mm ID x 1mm Width | Pack of 30 VMQ Seal Rings helps — illustrative scenarios, not customer reviews.