Skelang Walnut Wood Veneer Edge Banding 2 Rolls | 1.9cm x 15.24m (3/4" x 50') Preglued Iron-on Wood Tape

• The information below is per-pack only
• Material: Real walnut wood veneer edge banding
• Size: 3/4 inch ×50 feet(W*L)
• Adhesive Attach: The pre-glue backing was a nice touch and easy to work well by the iron or the edgebander machine. The strip attached quickly and firmly
• Perfect appearance: Create durable and aesthetically pleasing trim edges during finish carpentry
• Application: Used to cover the exposed sides of materials such as plywood, particle board ,hardboard or medium density fiber board

• Prepare the Surface — Ensure the edge of your material (plywood, MDF, particle board) is clean, dry, and sanded smooth. Trim any excess material to create a clean edge for optimal adhesion. Measure and cut the veneer tape to the required length, allowing a slight overlap for a perfect finish.
• Apply Heat — Set a household iron to a medium-high heat setting (test on a scrap piece first to find the right temperature). Avoid using steam. Gently heat the veneer strip along its length, focusing on the pre-glued adhesive side.
• Bond the Veneer — Carefully align the heated veneer strip onto the prepared edge of your material. Press down firmly and evenly with the hot iron, moving slowly along the entire length to ensure the adhesive melts and bonds securely. Apply consistent pressure for about 10-15 seconds per section.
• Trim and Finish — Allow the veneer to cool completely. Once cool, use a sharp utility knife or a specialized edge banding trimmer to carefully trim any excess veneer from the ends and sides. Lightly sand the edges if needed for a perfectly smooth finish.

Typical situations where Skelang Walnut Wood Veneer Edge Banding 2 Rolls | 1.9cm x 15.24m (3/4" x 50') Preglued Iron-on Wood Tape helps — illustrative scenarios, not customer reviews.