elechawk SH1.0 Connectors and Pre-Crimped Silicone Cables 15cm (0.5ft) | Essential for FPV Drone Flight Controllers

• Included 15cm Pre-crimped SH1.0 to SH1.0 Cables * 240pcs ( 6 colors, each color 40 cables) 3P*20pcs 4P*20pcs 5P*20pcs 6P*20pcs 7P*20pcs 8P*10pcs 9P*10pcs 10P*10pcs 12P*10pcs Diameter 1 mm Heat shrinkable tube * 100pcs Tweezer * 1pcs
• You can make an arbitrary cable by just plugging the terminal of the cable into the connector manually
• Ultra soft silicone wire, still has very good flexibility at low temperature.
• Suitable for SparkFun Qwiic Adafruit STEMMA QT Connect System, Flight Controller like SpeedyBee F405 Holybro Kakute H7 F7 T-Motor Velox F7, etc.
• You can achieve connection between flight controller and camera, VTX, GPS, Telemetry module, Bluetooth module, OSD, or ultrasonic sensor etc.

• Select Wire and Connector — Choose a pre-crimped silicone wire from the 6 available colors and select the appropriate pin count (3P to 12P) connector from the kit based on your flight controller and component requirements.
• Assemble Cable — If creating a custom length or replacing a wire, carefully insert the terminal end of the silicone wire into the desired pin position within the SH1.0 connector. Ensure a secure fit.
• Secure Connection — Once the wire is connected, slide a heat shrinkable tube over the connection point. Use a heat gun or lighter (carefully) to shrink the tube, providing insulation and strain relief for the connection.
• Connect to Flight Controller — Plug the assembled SH1.0 cable into the corresponding port on your FPV drone's flight controller, camera, VTX, GPS, or other module. Ensure correct pin orientation.

Typical situations where elechawk SH1.0 Connectors and Pre-Crimped Silicone Cables 15cm (0.5ft) | Essential for FPV Drone Flight Controllers helps — illustrative scenarios, not customer reviews.