DIYmall L298N Motor Drive Controller Board Module Dual H Bridge 4.06 x 4.06 x 2.03 cm | High Power, Low Heat, Arduino Compatible

• L298N as main chip,low heat,outstanding anti-interference performance
• High working power to 46v,large current can reach 3A MAX and continue current is 2A, power to 25w
• Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors
• Built-in 78M05,get power from drive power,however, when drive power over12V, please use the external 5v power as power supply
• Large capacity filter capacitance,afterflow protection diode, more stable and reliable

• Connect Power Supply — Supply 5V-46V DC to the power input terminals, ensuring correct polarity. Use a stable power source for consistent performance.
• Wire to Microcontroller — Connect input pins to Arduino digital pins, ground to ground, and enable signals as per your motor control logic.
• Test Motor Operation — Upload your control code, power on, and verify motor response. Adjust PWM or direction signals for desired movement.

Typical situations where DIYmall L298N Motor Drive Controller Board Module Dual H Bridge 4.06 x 4.06 x 2.03 cm | High Power helps — illustrative scenarios, not customer reviews.