HEATIT JHSF1-CT 12FT Self-Regulating Heating Cable | 120V Pipe & Roof Freeze Protection

• ETL Certified for Superior Safety — ETL certification, trusted in North America, ensures safety and quality compliance with rigorous standards. Our self-regulating heating cable holds full ETL certification, guaranteeing exceptional performance and reliability. The plug is also UL certified for extra safety. Always choose a fully certified heating cable for true safety. Plug-only certification is insufficient; the entire cable must be certified.
• More functional — Suitable for use on plastic and metal water pipes( including inlet pipes, drain pipes, sewer, palm tree frost protection etc). Industrial grade self-regulating heating cable. The cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheating risk. More Safe. Can be used by straight, spiral, and overlap. More functional.
• Fluoropolymer Out Jacket — (One of the most heavy-duty plastic material) as the out jacket. Can be used underwater application. Please keep the connection (waterproof IP65) between the orange cold lead and black heating cable above the water. The black heating cable including end seal meets waterproof IP68. JHSF1-CT cables are configured for use in nonhazardous and hazardous locations, including areas where corrosives may be present.
• Protect pipes up to 2 1/2" in diameter — For better freeze protection, at least 1/2 inch thick or thicker insulation material is recommended, especially for extremely cold weather. If the ambient temperature is lower than -20°F(-29°C), please use 1" thick insulation material. Pre-assembled, Including grounded plug with light, easy to install and use without built in thermostat. 120 volt, 5 watts/ft at 50 degrees F for pipe freeze protection.
• Roof deicing application — Can be used on flat roofs, metal roofs, asphalt roofs, rubber roofs, slate roofs, stone roofs, metal roofs, ceramic roofs, composite (tar and gravel) roofs and so on. Rated 6W/ft at 32°F (0°C) for roof deicing. For roof deicing applications, you may need to buy clips and hangers separately. › See more product details

• Measure and prepare — Measure pipe diameter, select appropriate cable length. Keep connection points above water level. Ensure insulation is at least 0.5 inch thick.
• Lay the cable — Wrap cable spirally or straight along pipe or roof surface. Secure with clips or hangers (sold separately). Keep connection above water for underwater use.
• Connect and test — Plug into 120V power source. Check for proper operation. Ensure waterproof connection points are sealed. Use in ambient temperatures supported (-20°F to 50°F).

Typical situations where HEATIT JHSF1-CT 12FT Self-Regulating Heating Cable | 120V Pipe & Roof Freeze Protection helps — illustrative scenarios, not customer reviews.