elechawk GH1.25 to Dupont 2.54 Pre-Crimped Cables and Connectors Kit 180pcs | Electronics Cable Connectors

• Included 20cm Pre-crimped GH1.25 to Dupont2.54 Cables * 180pcs ( 6 colors, each color 30 cables), GH1.25 and Dupont2.54 connectors, Diameter 1 mm Heat shrinkable tube * 100pcs and Tweezer * 1pcs
• You can make an arbitrary cable by just plugging the terminal of the cable into the connector manually
• Suitable for Pixhawk4, Pixhawk6C, 6X, Pixhawk2 the cube, Pixhack, Pixracer, PXFmini, CUAV v5, EDGE, and Inspire, Phantom and Raspberry Pi etc. flight controller
• You can achieve connection between flight controller and camera, VTX, GPS, Telemetry module, Bluetooth module, OSD, or ultrasonic sensor etc.
• Ultra soft silicone wire, still has very good flexibility at low temperature.

• Select Connectors and Wires — Choose the appropriate GH1.25 or Dupont 2.54 connector and pre-crimped wire based on the pin count required for your connection between flight controllers, sensors, or modules.
• Assemble Custom Cables — Manually plug the terminal of the wire into the chosen connector. You can arrange the color order arbitrarily to match your wiring diagram or for easy identification.
• Secure Connections — Use the included heat shrinkable tubes to secure and insulate the connections. Slide a tube over the wire before crimping, then heat gently to shrink it around the connection point.
• Integrate into Project — Connect your custom-made cables to your flight controller, camera, GPS, or other electronic components. The flexible silicone wire helps minimize vibration transfer.

Typical situations where elechawk GH1.25 to Dupont 2.54 Pre-Crimped Cables and Connectors Kit 180pcs | Electronics Cable Connectors helps — illustrative scenarios, not customer reviews.