Delamu Mini Cable Wire Hider for Wall, 325 cm (128 in) Black | Conceals Single Thin Cord

• One-Mini-Cord Channel Cord Hider: A good choice when you only have one Mini cord about 0.23" (5.8 mm) in diameter to hide. Ideally suited for covering one cable such as lamp cable, speaker cable, Ultra-thin TV/Monitor cable (Not suitable for Cat5 or Cat6 network cable)
• Total Length 128" Wire Hider Covers for Cords on Wall: Cable hider contains 9 channels and 9 pre-cut adhesive foam tapes. The attached tape has been upgraded to higher quality and stronger adhesion. You can follow the instructions for flexibility in securing cable cover and one cord where needed, rather than damaging your wall with screws (not suitable for textured walls)
• Finished Installation with Connector-Free Design in Minutes: For easy installation, the Delamu cord covers for wires on wall have no connectors. Even without experience, installation is a breeze. Just peel and stick the double-sided tape to the back of the channel, press it to the wall, put one cord in, and close the cover
• Hide The Unsightly Cable: This paintable and cuttable wall cord cable hider has an extremely slender appearance and a round arc angle profile that subtly matches the wall. Without messy cords, there is more room in your home and office for you to move around
• Household Security First: Exposed and unsightly cords may trip up your family. Babies or pets chewing and playing with cables are more likely to cause danger. Install Delamu cord cable management kit to organize unsightly cables and prevent unpredictable accidents

• Prepare the Surface — Clean the wall area where you plan to install the cord hider. Ensure it is dry, dust-free, and smooth for optimal adhesive performance. Avoid textured or uneven surfaces for best results.
• Apply Adhesive and Mount — Peel the protective backing from the adhesive tape on the back of the Delamu channel. Press the channel firmly onto the prepared wall surface and hold for a few seconds to ensure a secure bond.
• Insert Cable and Close — Gently place your single thin cable (approx. 5.8mm diameter) into the channel. Snap or close the cover over the cable to secure it within the raceway, instantly hiding the wire.
• Customize and Finish — If needed, cut the channel to your desired length using scissors or a utility knife. You can also paint the raceway to match your wall color for a seamless, integrated appearance.

Typical situations where Delamu Mini Cable Wire Hider for Wall helps — illustrative scenarios, not customer reviews.