CQRobot 100 Pieces Green Standard Computer Jumper Caps with Handle 2.54mm (0.1 Inch) | For Arduino Raspberry Pi PCB PC DVD HDD Motherboard

• These are two pin jumpers with handle (also called shunts) that will create an electrical connection for the 2.54 mm (0.1 inch) male pin headers. Commonly used to modify settings on a board or device;
• Mother board jumper is a manual switch on the motherboard, Through the jumper cap connected to different jumpers PIN, You can change the motherboard circuit;
• The most common motherboard jumpers are mainly two, One is only two needles, The other part is jumper cap;
• Jumper cap, Which is an active part, The outer layer is insulated plastic, The inner conductive material can be inserted in the jumper pin above the two jumper pin connected;
• 100 pieces green standard computer jumper caps with handle, PP plastic box packaging.

• Identify Target Pins — Locate the two adjacent pin headers on your motherboard, development board (like Arduino or Raspberry Pi), or other electronic device that require a jumper connection for configuration.
• Position the Jumper Cap — Take one green jumper cap with a handle and align the inner conductive material with the two target pins. Ensure the cap is oriented correctly to bridge both pins.
• Secure the Connection — Gently push the jumper cap onto the pins until it is firmly seated. This action completes the circuit, effectively setting the device to the 'ON' state for that specific configuration.
• Remove for Disconnection — To disconnect the circuit or change the configuration, carefully pull the jumper cap off the pins. This places the circuit in the 'OFF' state.

Typical situations where CQRobot 100 Pieces Green Standard Computer Jumper Caps with Handle 2.54mm (0.1 Inch) | For Arduino Raspberry Pi PCB PC DVD HDD Motherboard helps — illustrative scenarios, not customer reviews.