Hadwoer 50PCS Replacement Cutting Blades Set | 30/45/60 Degree Deep Cut Blades for Cricut Machines

• You will get: 50Pcs 45 degree standard blades (red cap), This will be a perfect compatible with maker blade, which can save your investment in this kind of wearing parts
• Compatibility: These replacement cutting blades are fully compatible with Explorer Air 2/Air 3/Explore 4/Maker/Maker 3/ Expression, compatible with Maker machines
• Broad applicability: The 45 degree cutting blade is a standard cutting blade, suitable for cutting most general media: such as foiled card stock, poster board, and computer paper, vinyl, stickers, foam sheets, and so on
• Cutting Sharp & Smoothy: These replacement cut blades are made of quality cemented carbide,Sharp and durable, you can cut your project fluently and cut clean with no dragging and no skipped spots
• Tips: In order to avoid scratching your fingers, these blades are wrapped in a rubber cover, Please pull them out of the cover during use. These knife blades must be adjusted manually according to different cutting materials

• Prepare Your Machine — Ensure your Cricut machine (Maker, Explore Air 2, etc.) is clean and ready. Select the appropriate blade housing for the 45-degree fine point blade.
• Install the Blade — Carefully remove the protective red cap from the Hadwoer blade. Insert the blade into the housing, ensuring it clicks securely into place. Manual adjustment may be needed based on material.
• Select Material & Cut — Place your chosen material (vinyl, cardstock, foam sheet) onto the cutting mat. Load the mat into the machine and select your design. Initiate the cut, ensuring the blade depth is set correctly for a clean result.

Typical situations where Hadwoer 50-Pack 45 Degree Fine Point Blades for Cricut Maker & Explore Air 2 | Cuts Vinyl helps — illustrative scenarios, not customer reviews.